How to Load an Additional Memory Card Into Your Samsung ML-4551ND
The following instructions will walk you through, step by step, on how to install an additional memory card to the SAMSUNG Mono Laser Printer ML- 4551ND
FITTING ADDITIONAL MEMORY CARD
IMPORTANT – Before attempting to fit the additional Card, turn off the power and disconnect power cable from the machine.
Tools Required: None.
Pull Out the Duplex Tray [Part Way]
Disconnect power cable before beginning to fit memory Card!
Lift slightly the ‘Duplex Tray’ located at the rear of the machine and pull out the tray until it is approximately half way out.
Remove Side Inspection Panel
Push Inspection Panel in slightly and slide panel to the right as illustrated opposite.
Lift the ‘Duplex’ Tray slightly and pull.
When panel has disengaged, tilt panel toward you and lift to remove completely.
Remove Existing Card
With the Inspection Panel removed the existing ‘Memory Card’ becomes visible.
The Card is held in place on either end by two spring clips. Using your thumbs push both clips [left & right] simultaneously to release the card outwards,
With the Card unclipped, remove by lifting up out of its plug in slot. With the Card removed, the slot for the additional Card becomes visible.
Note the slot at the bottom of the Memory card, this will ensure card can be only fitted one way
Fit New Memory Card
With the two black chips facing you, fit the new card into its plug in slot by tilting slightly forward, when correctly positioned push the card back until the spring clips snap into place.
New Card fitted
Note the two black chips must be facing out.
Refit Original Memory Card
Follow the same procedure, with the two black chips facing you, re-fit the original card into its plug in slot by tilting slightly forward, when correctly positioned push the card back until the spring clips snap into place.
Both Memory Cards fitted
Re-Assemble Side Panel & Duplex Tray
Tilt panel toward you and locate lugs on panel into slots.
Push back & slide Inspection Panel to the left until it clicks into place.
Push Duplex Tray back into place.
Reconnect Power Cable…