September 28, 2023

Saat Saak

The Future of Mind

How to Load an Additional Memory Card Into Your Samsung ML-4551ND

2 min read
How to Load an Additional Memory Card Into Your Samsung ML-4551NDThe following instructions will walk...

How to Load an Additional Memory Card Into Your Samsung ML-4551ND

The following instructions will walk you through, step by step, on how to install an additional memory card to the SAMSUNG Mono Laser Printer ML- 4551ND

FITTING ADDITIONAL MEMORY CARD

IMPORTANT – Before attempting to fit the additional Card, turn off the power and disconnect power cable from the machine.

Tools Required: None.

STEP ONE

Pull Out the Duplex Tray [Part Way]

Disconnect power cable before beginning to fit memory Card!

Lift slightly the ‘Duplex Tray’ located at the rear of the machine and pull out the tray until it is approximately half way out.

STEP TWO

Remove Side Inspection Panel

Push Inspection Panel in slightly and slide panel to the right as illustrated opposite.

Lift the ‘Duplex’ Tray slightly and pull.

When panel has disengaged, tilt panel toward you and lift to remove completely.

STEP THREE

Remove Existing Card

With the Inspection Panel removed the existing ‘Memory Card’ becomes visible.

The Card is held in place on either end by two spring clips. Using your thumbs push both clips [left & right] simultaneously to release the card outwards,

With the Card unclipped, remove by lifting up out of its plug in slot. With the Card removed, the slot for the additional Card becomes visible.

Note the slot at the bottom of the Memory card, this will ensure card can be only fitted one way

STEP FOUR

Fit New Memory Card

With the two black chips facing you, fit the new card into its plug in slot by tilting slightly forward, when correctly positioned push the card back until the spring clips snap into place.

New Card fitted

Note the two black chips must be facing out.

STEP FIVE

Refit Original Memory Card

Follow the same procedure, with the two black chips facing you, re-fit the original card into its plug in slot by tilting slightly forward, when correctly positioned push the card back until the spring clips snap into place.

Both Memory Cards fitted

STEP SIX

Re-Assemble Side Panel & Duplex Tray

Tilt panel toward you and locate lugs on panel into slots.

Push back & slide Inspection Panel to the left until it clicks into place.

Push Duplex Tray back into place.

Reconnect Power Cable

Copyright © All rights reserved. | Newsphere by AF themes.